Inserting The Readimanager Iam Into The Mgc+ Unit - Polycom DOC2238A Hardware Installation Manual

Chapter 2 - Hardware Installation
2-16

Inserting the ReadiManager IAM into the MGC+ Unit

To insert the Polycom ReadiConvene IAM blade:
1. After removing the left front panel from the MGC+ chassis, unpack the
ReadiManager IAM.
2. Insert the ReadiManager IAM into its slot and carefully slide it firmly
into the backplane, making sure that it is properly seated in its slot.
Figure 2-7: ReadiManager IAM insertion on the MGC+ unit
Tighten the four screws, securing the ReadiManager IAM to the MGC+
chassis.
When power on the MGC+ is ON, the ReadiManager IAM automatically boots
when it is inserted into its housing on the backplane. For more information see
Table 2-2 on page 2-12.