Decaling Instructions - Animo Optivend Choco Service Enclosure

WARNING
• Do not leave the unit during maintenance.
• Always follow the prescriptions, that are delivered
with the used descaling solvent.
• It is advisable to wear protecting glasses and
gloves during descaling.
• After descaling, run the appliance through at
least three cycles.
• Wash hands after descaling.
• Do not submerge or spray the unit.
• Have all repairs carried out by a qualified
technician.

4.2 Decaling instructions

Animo supplies Scale remover in the following
quantities:
• Scale remover per box (48 sachets of 50 gram)
art. no. 49007
• Scale remover can of 1 kg art. no. 00009
Time, equipment and tools required:
• Time: 45 minutes
• Animo scale remover, 2 sachets
or 8 - 10 tablespoons.
• Measuring cup 1l.
• Screwdriver
• Bucket or basin nearby.
1. Switch on the machine and leave it to heat up.
This has the advantage that the reservoir is
properly preheated so that a better and quicker
result is obtained during the descaling process.
2. Switch off the machine and pull the plug out of
the socket.
Remove the rear panel and take off the
3.
reservoir lid by removing the screws. Warning:
HOT!
4. Tap one litre of hot water out of the water
reservoir using the drain hose (fig.6-2) located
at the back of the machine.
5. First read the warnings and directions for use
on the sachets of Animo scale remover and
dissolve 2 sachets of 50 grams of Animo scale
remover in the measuring cup (8 - 10
tablespoons).
6. Pour the acid solution into the reservoir
(fig.7-1). The acid solution will now react with
the lime.
7. Leave this solution to penetrate for at least 10
minutes, until it stops fizzing.
8. During the penetration time use a brush to
spread the acid over the level electrodes
(fig. 7-2).
service enclosure 28
1
2
Fig. 6
1
2
Fig. 7
01/2007 (rev. 6) V2.0