Configuring A Micrologix 1400 Cip Generic Message Via Ethernet - Allen-Bradley MicroLogix 1400 Instruction Manual

efesotomasyon.com - Allen Bradley,Rockwell,plc,servo,drive
Configuring a
MicroLogix 1400 CIP
Generic Message via
Ethernet
Trigger MSG instruction. It should complete done, and OPC Test
Client should display the N7:0 data, as well as "Good" Sub Quality:
The MicroLogix 1400 supports CIP Generic messages over ethernet port.
This section describes how to configure a CIP Generic message when you
are use Ethernet communication channel 1 of the MicroLogix 1400. The
Network Configuration is shown below.
Backplane
Link ID 20
10.121.29.199
Link ID 16
The RSLogix Message Setup Screen is shown below. This screen is used to
setup "This Controller", "Target Device", and "Control Bits". Descriptions
of each of the elements follow.
Communications Instructions
ML 1400
10.121.29.144
DHRIO Link ID 24
Control Logix Gateway
A
B
Publication 1766-RM001A-EN-P - October 2008
461
Ethernet Hub
445941