Saving Your Project - Native Instruments MASCHINE MK3 Getting Started

The loop range now contains three Sections.
You will note that selecting a single Section amounts to selecting a one-Section-long
loop range.
10.3.2 Selecting a Loop Range using the Controller
On your controller:
1. Press SHIFT + SCENE
Arranger view).
2. Press and hold SHIFT
SHIFT + SCENE (Section) + Button 1).
3. Press and hold the pad corresponding to the start Section.
4. While holding the first pad, press the pad corresponding to the end Section.
The start and end Sections along with all Sections in-between are played one after the other in
a loop.
10.4

Saving Your Project

Again, it is recommended to regularly save your work. You can then open another Project or
close MASCHINE and take a break. Your tutorial Project will be recalled as it was the next time
you open it.
To save your Project in the software:
Press [Ctrl] + [S] ([command] + [S] on macOS) to save your Project.
►
To save your Project on the controller:
(Section) to access the Arranger view (if you are not already in the
+ SCENE (Section) to enter Section mode (or pin it by pressing
Creating an Arrangement
Selecting a Loop Range
MASCHINE - Getting Started - 151