Native Instruments MASCHINE MK3 Getting Started page 24

1. Turn the LINE OUT VOLUME
left-end stop to set the output volume to minimum.
2. Connect the LINE OUT L/R
active speakers using balanced cables with 1/4" TRS jack plugs. First, connect the
put channel with the left speaker, then the
3. Once you have connected the speakers to the device, set the volume knob on your active
speakers to 0 dB and turn them on.
4. Start the playback of a Project in MASCHINE or an audio file on your computer.
5. Gradually turn the
ler until you reach an appropriate listening level.
If you have a main mixer connected to your monitors, and various devices plugged into
your main mixer, you can simply add the MASCHINE controller to your setup by con-
necting its audio outputs to any stereo line input on your main mixer. Just follow the in-
structions above and replace the monitors' volume knob with the volume fader of the in-
put channel on your mixer to which you want to connect the MASCHINE controller.
knob on the rear panel of the MASCHINE controller to the
sockets on the rear panel of the MASCHINE controller to your
LINE OUT VOLUME knob on the rear panel of the MASCHINE control-
R output channel with the right speaker.
Setting Up MASCHINE
Setup Examples
L out-
MASCHINE - Getting Started - 24