Installing The Keyboard - Toshiba QOSMIO E10 Maintenance Manual

4 Replacement Procedures

Installing the keyboard

The following describes the procedure for installing the keyboard (See Figure 4-7, 4-8 and 4-
9).
1. Turn the keyboard upside down and place it on the palm rest as its face down.
Connect the keyboard flexible cable to the connector PJ3200 on the system board.
NOTE: After connecting the keyboard flexible cable, put the cable into the slit of the
computer.
2. Install the keyboard support plate and secure it with the following screws.
•
3. Turn the keyboard face up and put it on the computer. Make sure that there is no
space between the keyboard and the computer.
4. Install the keyboard and secure it with the following screws.
• M2.5×2.8B
5. Slide to set the speaker cover assembly and secure it with the following screw.
• M2.5×4B
6. Install the keyboard brace by pressing it from the topside.
4-20
M2.5×2.8B FLAT BIND screw
FLAT BIND screw
FLAT BIND screw x1
4.5 Keyboard/Bluetooth
x2
x2
QOSMIO E10 Maintenance Manual (960-492)