Expansion Test - Toshiba QOSMIO E10 Maintenance Manual

3 Tests and Diagnostics

3.16 Expansion Test

To execute the expansion test, select 11 from the DIAGNOSTICS TEST MENU, press Enter
and follow the directions on the screen.
NOTE: To execute this subtest, the PC card wraparound connector is required.
Subtest 01 PCMCIA wrap around
This subtest checks the following signal line of the PC card slot:
Address line
REG#, CE#1, CE#2 line
Data line
Speaker line
Wait line
BSY#, BVD1 line
This subtest is executed in the following order:
Sub# Address
01 00001
00001
02 00002
03 00003
04 00004
05 00005
NOTE: Select the subtest number01, The following message will appear:
Test slot number select (1:slot0, 2:slot1, 0:slot0&1)?
Subtest 02 RGB monitor ID
Connect a wraparound connector to CRT monitor for the test of ID acquisition.
This subtest is executed by using VESA command.
3-32
Good Bad
nn xx Address line
nn xx REG#, CE#1, CE#2
ww rr Data line
data
–– –– Speaker line
40,80 xx Wait line (40<xx<80)
nn xx Other lines (BSY#, BVD1)
QOSMIO E10 Maintenance Manual (960-492)
3.16 Expansion Test
Contents
nn=A0, 90, 80, 00
ww=write data, rr=read
NN=21, 00