Toshiba QOSMIO E10 Maintenance Manual page 254

4 Replacement Procedures
Installing the system board
The following describes the procedure for installing the system board (See Figure 4-26).
1. Install the system board and secure it with the following screws.
• M2.5×4B
NOTE: When installing the system board, make sure Wireless LAN KILL switch is fit to
the slit of the base assembly. Also, make sure the RTC battery cable is not caught
between the base assembly and system board.
2. Install the BATT CONN cover to the base assembly.
3. Arrange the RTC battery cable along the guide and connect it to the connector
PJ8490 on the system board.
4-46
FLAT BIND screw
QOSMIO E10 Maintenance Manual (960-492)
4.15 System board
x3