Installing The Hinge Cover And Keyboard - Toshiba NB250 Maintenance Manual

4 Replacement Procedures

Installing the Hinge Cover and Keyboard

Install the hinge cover and keyboard according to the following procedures.
1. Attach the cable from the underside of the keyboard to the connector on the logic upper
assembly.
2. Seat the keyboard in its correct position making sure the four hooks on either side are
fastened.
3. Seat the hinge cover in the correct position and firmly click into place.
4. Close the laptop.
5. Turn the laptop upside down. Make sure all three hinge cap hooks are firmly in place.
6. Secure the laptop with twelve screws as indicated in Figure 4.8:
 seven M2.5x6 screws
 five M2.5x4 screws
7. Fasten any WLAN or modem antennas to their respective connectors.
NB250/NB255 Maintenance Manual
4.5 WLAN Card
4-20