Wireless Lan Test Program - Toshiba QOSMIO E10 Maintenance Manual

3.26 Wireless LAN Test Program

3.26 Wireless LAN Test Program
This section describes how to perform the wireless LAN transmitting-receiving test with the
test program. To execute the Wireless LAN Test, use the Diagnostics disk for Wireless LAN
test. Finish the tests of the Main test program by selecting 99 - EXIT TO DIAGNOSTICS
MENU in the DIAGNOSTIC TEST MENU. Then in the DIAGNOSTICS MENU, select 9 -
EXIT TO MS-DOS.
Insert the Diagnostics disk for Wireless LAN test into the Floppy Disk Drive. Turn on the
power while pressing U.
The following menu appears in the display.
******Intel Calexico 11b/g Card Maintenance test Menu******
*
* 1 : SKU check of Module
*
* 2 : MAC Address Check
*
* 3 : Antenna Check & communication test of 11b mode
*
* 4 : communication test of 11g mode
*
* 5 : All the tests of Calexico 11g Card
* (SKU & MAC Check, 11b/g communication test)
*
***********************************************************
SELECT TEST No, (1-5) :
To execute the subtest, input the subtest number and press Enter.
Subtest01 SKU check of module
This subtest displays SKU information.
Confirm if there is no difference between the SKU information appeared on
the display and the information of the label on the back of the wireless LAN
Card.
Press any key and return to the test menu.
QOSMIO E10 Maintenance Manual (960-492)
3 Tests and Diagnostics
*
*
*
*
*
*
*
*
*
*
*
*
3-55