Toshiba QOSMIO E10 Maintenance Manual page 236

4 Replacement Procedures
3. Remove the following screws to remove the side bracket from the optical drive.
• M2×3C
•
Stepping screw
Installing the optical drive
The following describes the procedure for installing the optical drive (See Figure 4-13 and
4-14).
1. Attach the side bracket to the optical drive and secure it with the following screws.
• M2×3C
•
2. Insert the optical drive assembly into the slot and connect it to the connector PJ1820
on the system board.
3. Secure the optical drive assembly with the following screws.
• M2.5×4B
4-28
SUPER THIN HEAD screw
Stepping screw
Figure 4-14 Disassembling the side bracket
SUPER THIN HEAD screw
Stepping screw
FLAT BIND screw
x2
x1
Side bracket
M2×3C SUPER THIN HEAD
x2
x1
x2
QOSMIO E10 Maintenance Manual (960-492)
4.8 Optical drive