Installing The Display Assembly - Toshiba QOSMIO E10 Maintenance Manual

4.9 Display assembly

Installing the display assembly

The following describes the procedure for installing the display assembly (See Figure 4-15,
4-16, 4-17, and 4-18).
1. Fit the PC card eject button into the slot of the display assembly and install the
display assembly on the base assembly.
NOTE: Make sure there is no cable caught between the display assembly and base
assembly.
2. Connect the SJ board flat cable to the connector PJ9550 on the sound board.
3. Connect the LCD harness to the PJ5600 on the system board.
4. Connect the touch pad cable to the PJ3201 on the system board.
5. Turn up the insulator and arrange the wireless LAN antenna relay cables along the
guide of the display assembly.
6. Secure the display assembly with the following screws.
• M2.5×6B
7. Secure the base assembly with the following screws.
• M2.5×10B
• M2.5×10B
• M2.5×4B
NOTE: Be sure to apply the locktight to the screws instructed in the figure above.
QOSMIO E10 Maintenance Manual (960-492)
FLAT BIND screw
FLAT BIND screw
FLAT BIND screw
(Locktight)
FLAT BIND screw
4 Replacement Procedures
x2
x12 ("10" in the figure)
x2 ("10+L" in the figure)
x1 ("4" in the figure)
4-33