Sd Board/Mdc; Sd Board - Toshiba QOSMIO E10 Maintenance Manual

4.12 SD board/MDC

4.12 SD board/MDC

4.12.1 SD board

Removing the SD board
The following describes the procedure for removing the SD board (See Figure 4-22).
1. Disconnect the SVP harness from the connector PJ9625 on the TV board and
connector PJ5801 on the system board.
2. Disconnect the SD board flat cable from the connector CN95000 on the system
board.
3. Disconnect the speaker cable L (red cable) and speaker cable R (blue cable) from
the connectors PJ6002 and PJ6003 on the SD board.
4. Disconnect the USB harness from the connector PJ4620 on the SD board.
5. Remove the following screws fixing the SD board.
• M2.5×4B FLAT BIND screw
6. After pulling up the SD board slightly, disconnect the SD board flat cable and SVP
harness from the connectors CN9510 and PJ9551 on the SD board.
7. Remove the SD board and RJ11 connector altogether from the base assembly.
QOSMIO E10 Maintenance Manual (960-492)
4 Replacement Procedures
x3
4-39