Toshiba QOSMIO E10 Maintenance Manual page 70

2 Troubleshooting Procedures
Table 2-4 Debug port (Boot mode) error status (5/8)
D port status
(F107h) CMOS default setting check
ACPI table initialization (for
execution of option ROM)
Initialization of devices which
need initialization before PCI bus
initialization
Password Initialization
F108h PCI bus initialization (connection
of DS Bus)
Initialization of LAN information
Check of WakeUp factor
F109h Task generation for waiting
INIT_PCI completion
CMOS data initialization (2)
PnP initialization
Setting of setup items
Waiting for the completion of
Multi-box status check
H/W setting based on resource
F10AH Task generation for waiting PnP
resource making completion
Serial interruption control
PnP H/W initialization
PCI automatic configuration
2-24
Inspection items
PIC initialization
PIC test
2.4 System Board Troubleshooting
Details
Defaults set if bad battery, bad checksum (ROM,
CMOS) is detected)
AC'97 control
Initialization of temperature control information
KBC initialization
VGA display off, Reset control
Sound initialization
PC multi-box status acquisition
HC initialization, USB Device recognition and
initialization
Control of built-in LAN permission/prohibition
(before use of interruption)
PC card slot initialization
SIO initialization (for models supporting SIO)
FIR initialization (for models supporting FIR)
Making of work for automatic configuration
QOSMIO E10 Maintenance Manual (960-492)