Table of Contents
Advertisement
7.6.2 Edit for the Password setting
The flowchart illustrating Password Setup Editing is shown below. Note that pressing
Cancel at any time returns to the previous Menu or cancels the operation in course.
Refer to chapter 7.8 for Editing.
This menu is used to set the Password. Please note the following:
1)
The default value is 0 (zero) and is equivalent to disabling the Password.
2)
Entering a non-zero value via this Menu automatically enables the Password.
3)
Enter 0 (zero) to disable the Password.
4)
If the Password is enabled, it also becomes active when the "OPTION1" menu is
accessed. As soon as it is attempted to access a Password protected Menu or
menu item, the Password will be requested. If the Password is correctly entered,
it will be deactivated from that moment on, i.e. it is possible to access other
protected Menus and/or menu items without having to specify the password
again.
5)
The Password is automatically reactivated when the SBI card Main Menu is
exited.
The following message is displayed to confirm the Password:
Pressing the "+" key confirms the Password and the system returns to the imme-
diately superior Menu level; from this moment on, the Password is enabled if a
non-zero value was entered or disabled if zero was specified.
Pressing the "-" key returns to Password Edit mode.
Enter Password pressed
no
——————
SBI-DN
Password: XXXXX
Conf. (+yes / -no)
Password enabled
or active ?
yes
Enter password
no
Password OK ?
yes
Enter new Password
no
Confirm Password?
yes
Save in E2PROM
Exit
Interface Board DeviceNet
TSB8110
Warning
——————
Exit
61
Advertisement
Table of Contents
