Table of Contents
Advertisement
2.6 LEDS
PWR
+5V power supply.
RST
Reset active.
H1
+5V power supply on the RS 485 driver side. It is supplied by
the Bus.
RUN
It is on when the microcontroller is operating.
OP
It is on when the Master/Slave connection is established.
AL0
It blinks when the "Duplicate MAC ID" test has not been passed.
AL1, AL2
Not used and are always off.
2.7 TECHNICAL SPECIFICATIONS
Storage temperature:
Operating temperature:
Such temperatures are suitable to be used with those of the drive, which they are
connected to.
2.8 INTERFACE
The board has to be installed on the regulation board so that the XO connector of
the SBI board is placed near the XO connector of the regulation board, thus keeping
the DeviceNet connection terminal in a downward position.
As for the mechanical connection use the kit delivered with the board.
As for the electrical connection use the 40-pole flat cable included in the kit.
As for the Bus connection use a shielded "twisted pair cable".
The connection among the single boards is carried out via a shielded cable as
shown in the figure below:
SBI-DN
14
——————
GEFRAN
-20°... +70°C (-68...+158°F)
0°... +55°C (32...+131°F)
SBI-DN
Interface Board DeviceNet
SBI-DN
PE
Shield
——————
Advertisement
Table of Contents
