Table of Contents
Advertisement
6.0 FUNCTION ERROR CODES
The following table shows the different error codes which could be generated when
a service is executed.
OK no error
Parameter not exist
Reserved
Control Access denied
Reserved
Attribute Access denied
Type value error
Reserved
Destination option not exist
Parameter Access Conflict
Value out of the maximun range
Value out of the minimun range
Value not supported
Parameter Configuration Conflict
Command Submitted
Reserved
Unknown Command
Read only Parameter
Write not allowed
Value out of constant limits
State not correct
Password
Type Unknown
Hardware Fail
Checksum Fail
Reserved
Reserved
NOK generic
User defined
Meaning:
Parameter not exist
Control Access denied
Attribute Access denied
Type value error
52
——————
GEFRAN
RESULT
The specified parameter does not exist.
The access is denied because of the Drive
condition.
The parameter attributes do not allow the
access.
The type of specified value is wrong.
Interface Board DeviceNet
VALUE
0000H
0001H
0002H
0003H
0004H
0005H
0006H
0007H-000FH
0010H
0011H
0012H
0013H
0014H
0015H
0016H
0017H
0018H
0019H
001AH
001BH
001CH
001DH
001EH
0030H
0031H
001FH-007CH
0082H-00FCH
00FFH
0100H-FFFFH
t6000
——————
Advertisement
Table of Contents
