Table of Contents
Advertisement
Enter(S->M/M->S) POLL pressed
no
The validity of the specified Drive parameters is checked by the Drive.
If the Drive returns with an error code, the following message will be displayed on
the keypad:
The error code generated by the Drive is displayed in hexadecimal format; error
codes are listed in chapter 6.0.
If data entry is correct, the following message will be displayed:
This message automatically disappears after two seconds, or upon pressing the
Cancel key.
Refer to chaper 7.6.1 for messages regarding Password entry.
——————
SBI-DN
yes
Channel exceed
configuration data
no
Password enabled
or active ?
yes
Enter password
no
Password OK ?
yes
Enter drive parameter
Send to the drive
no
Drive reply OK ?
yes
Save in E2PROM
Exit
Par. not assign.
Err. code: XXXXh
ENTER OK !
Interface Board DeviceNet
Warning
Warning
Warning
TSB8040
TSB8050
——————
Exit
Exit
Exit
57
Advertisement
Table of Contents
