Table of Contents
Advertisement
Destination option not exist
Parameter Access Conflict
Value out of the max range
Value out of the min range
Value not supported
Parameter Configuration Conflict
Command Submitted
Unknown Command
Read only Parameter
Write not allowed
Value out of constant limits
State not correct
Password
Type Unknown
Hardware Fail
Checksum Fail
NOK generic
——————
SBI-DN
The destination option does not exist on the
knot.
The access to the addressed parameter is
denied (for example if we have a writing
command and the parameter is connected
to an external input).
The value is out of the maximum range.
The value is out of the minimum range.
The value is included in the range but it is not
allowed.
The access to the addressed parameter is
denied because of a system configuration
conflict.
The command has been transmitted but it
is not possible to know if it has been carried
out.
The command is unknown.
The parameter has an only reading attribute.
The writing function is not allowed because
of the slave conditions.
The value is out of the constant limits.
The control state does not allow the command
to be carried out.
The command has not been carried out be-
cause the password is active.
The parameter type is unknown.
The access is denied because of a hardware
failure.
The access is denied because of a checksum
error.
The access is denied because of a non spe-
cified error.
Interface Board DeviceNet
——————
53
Advertisement
Table of Contents
