Table of Contents
Advertisement
POLL S->M
They show the indexes (with or without Offset, see par. 7.2) of the Drive parameters
assigned to the Polling I/O function.
By pressing the keys Cursor-Up/Cursor-Down it is possible to move inside the chan-
nel Menus; the key Cancel allows to go back to the upper level Menus. By pressing
the key Enter you enter the Edit condition of the Polling I/O function.
The indexes of the Drive parameters are displayed an 5 digit format.
The parameter index is not automatically updated: it means that if a new assign-
ment is carried out by a Master while the index displaying is active, the new values
are not automatically displayed but it is necessary to exit and enter the Polling I/O
Menu again.
7.3.1 Edit for Drive parameter assignment to the Polling I/O function
The flowchart illustrating Editing of Drive parameter assignments to the Polling
I/O functions is shown below. Note that pressing Cancel at any time returns to the
previous Menu or cancels the operation in course. Refer to chapter 7.8 for Editing.
Further Editing information are given in par. 7.8.
56
——————
GEFRAN
POLL SM CHAN 0
Index: XXXXX
POLL SM CHAN 1
Index: XXXXX
POLL SM CHAN 2
Index: XXXXX
POLL SM CHAN 3
Index: XXXXX
Interface Board DeviceNet
POLL M->S
POLL MS CHAN 0
Index: XXXXX
POLL MS CHAN 1
Index: XXXXX
POLL MS CHAN 2
Index: XXXXX
POLL MS CHAN 3
Index: XXXXX
——————
DNM0030
Advertisement
Table of Contents
