7.5 DRIVE VIRTUAL DIGITAL I/O PARAMETER ASSIGNMENT
EDITING
The flowchart illustrating Editing of Drive parameter assignments to Virtual Digital
I/O is shown below. Note that pressing Cancel at any time returns to the previous
Menu or cancels the operation in course. Refer to chapter 7.8 for Editing.
Enter virtual digital
(Input/Output) pressed
no
The validity of the specified Drive parameters is checked by the Drive. If the Drive
returns with an error code, the following message will be displayed on the keypad
screen:
The error code generated by the Drive is displayed in hexadecimal format; error
codes are listed in chapter 6.0. If parameter specification is correct, the following
message will be displayed:
This message automatically disappears after two seconds, or upon pressing the
Cancel key.
Refer to section 7.6.1 for messages regarding Password entry.
——————
SBI-DN
Password enabled
or active ?
yes
Enter password
no
Password OK ?
yes
Enter parameter index
Send to the drive
no
Drive reply OK ?
yes
Save in E2PROM
Exit
Par. not assign.
Err. code: XXXXh
ENTER OK !
Interface Board DeviceNet
Warning
Warning
TSB8040
TSB8050
——————
Exit
Exit
59