Table of Contents
Advertisement
Figure 3A
Figure 3B
SBI-OFM-32
SBI-OFS-32
2.
Fasten with screws and no.4 standoffs L=26.5mm the SBI board to the regu-
lation board, see figure 3A. In case there is the SBI-OFM/OFS-32 card, fasten
the SBI card to the drive regulation card by means of screws and 2 standoffs
L=10 mm + 2 standoffs L=26.5mm, see figure 3B.
The BUS connector is turned in the same direction as the regulation board
terminals.
3.
The flat cable is connected between the XO connector placed on the R-TPD32-
EV card and SBI-DN card. In case there is the APC300 card, connect the flat
cable from APC300 to XO connector on SBI-DN card.
4.
The Baud Rate of the SBI board is set via the Switches 7 and 8 of the Dipswi-
tch S1. The Baud Rate is detected only when the board is switched on and it
can be modified only by switching off and swtching on the board again.Table
2 shows the relation between the DIP-Switches and the selectable Baud Rate
value. The Default value is 125 Kbaud.
——————
SBI-DN
Interface Board DeviceNet
SBI-DN
Distanziali/Stands-off
L=26,5mm (x4)
R-TPD32-EV
SBI-DN
Distanziali/Stands-off
L=10mm (x2)
Distanziali/Stands-off
L=26,5mm (x2)
R-TPD32-EV
——————
11
Advertisement
Table of Contents
