GE L90 Instruction Manual page 93

3 HARDWARE
6. Re-insert the G.703 module. Take care to ensure that the correct module type is inserted into the correct slot position.
The ejector/inserter clips located at the top and at the bottom of each module must be in the disengaged position as
the module is smoothly inserted into the slot. Once the clips have cleared the raised edge of the chassis, engage the
clips simultaneously. When the clips have locked into position, the module will be fully inserted.
Table 3–5: G.703 TIMING SELECTIONS
SWITCHES FUNCTION
S1 OFF octet timing disabled
ON octet timing 8 kHz
S5 and S6 S5 = OFF and S6 = OFF
S5 = ON and S6 = OFF
S5 = OFF and S6 = ON
S5 = ON and S6 = ON
c) G.703 OCTET TIMING
If octet timing is enabled (ON), this 8 kHz signal will be asserted during the violation of bit 8 (LSB) necessary for connecting
to higher order systems. When L90s are connected back to back, octet timing should be disabled (OFF).
d) G.703 TIMING MODES
There are two timing modes for the G.703 module: internal timing mode and loop timing mode (default).
• Internal Timing Mode: The system clock is generated internally. Therefore, the G.703 timing selection should be in
the internal timing mode for back-to-back (UR-to-UR) connections. For back-to-back connections, set for octet timing
(S1 = OFF) and timing mode to internal timing (S5 = ON and S6 = OFF).
• Loop Timing Mode: The system clock is derived from the received line signal. Therefore, the G.703 timing selection
should be in loop timing mode for connections to higher order systems. For connection to a higher order system (UR-
to-multiplexer, factory defaults), set to octet timing (S1 = ON) and set timing mode to loop timing (S5 = OFF and S6 =
OFF).
GE Multilin
Figure 3–32: G.703 TIMING SELECTION SWITCH SETTING
loop timing mode
internal timing mode
minimum remote loopback mode
dual loopback mode
L90 Line Current Differential System
3.3 PILOT CHANNEL COMMUNICATIONS
3
3-31