GE L90 Instruction Manual page 108

3.4 MANAGED ETHERNET SWITCH MODULES
2.4. The following window is displayed. Select the Use the Following IP Address option and enter appropriate IP
address, Subnet mask, and Default gateway values. It may be necessary to contact your network administra-
tor for assistance.
3
2.5. Save the settings by clicking the OK button.
2.6. Click the Close button to exit the LAN properties window.
3. Connect your PC to port 1 or port 2 of the Ethernet switch module (with an RJ-45 – CAT5 cable).
4. Verify that the two LEDs beside the connected port turn green.
5. After few seconds you should see your local area connection attempting to connect to the switch. Once connected,
check your IP address by going to bottom of your screen and right-clicking the Local Area Connection icon as shown
below.
3-46 L90 Line Current Differential System
3 HARDWARE
GE Multilin