GE L90 Instruction Manual page 107
Ur series line current differential system
Hide thumbs
Also See for L90:
- Instruction manual (900 pages) ,
- Communications manual (532 pages) ,
- Instruction manual (470 pages)
Table of Contents
Advertisement
3 HARDWARE
b) CONFIGURING LAN COMMUNICATIONS
The following procedure describes how to initially configure the Ethernet switch to work on your LAN.
1.
Initiate communications from a PC to the L90 through a front panel serial connection (refer to the Configuring serial
communications section in chapter 1 for details), or if you are familiar with the UR keypad you can use it to set up the
network IP address and check the Modbus slave address and Modbus TCP port.
2.
Ensure that the PC and the L90 are on the same IP network.
If your computer is on another network or has a dynamic IP address assigned upon a network login, then setup your
own IP address as follows
2.1.
From the Windows Start Menu, select the Settings > Network Connections menu item.
2.2.
Right-click on the Local Area Connection icon and select the Properties item. This will open the LAN proper-
ties window.
2.3.
Click the Properties button as shown below.
GE Multilin
3.4 MANAGED ETHERNET SWITCH MODULES
L90 Line Current Differential System
3
3-45
Advertisement
Table of Contents
