Mitsubishi Electric Q01UCPU User Manual page 564

(4) Drive and file
Item
A memory card (SRAM card, ATA card, or Flash
Boot file setting
card) cannot be specified as a transfer source.
A device comment file cannot be stored in an
SRAM card.
Device comment
A device comment file cannot be stored in an
ATA card nor Flash card.
An initial device value file cannot be stored in an
SRAM card.
Initial device value
An initial device value file cannot be stored in an
ATA card nor Flash card.
A local device file cannot be stored in an SRAM
Local device
card.
A file register file cannot be stored in an SRAM
card.
File register
A file register file cannot be stored in a Flash
card. (Sequence programs only can read file
register data in a Flash card.)
A sampling trace file cannot be stored in an
Sampling trace
SRAM card.
CPU module change
A memory card cannot be specified as a backup
function with memory
destination or restoration source.
card
562
Precautions
*1
Replacement method
Specify an SD memory card as a transfer
source.
Store the file in the standard RAM.
Store the file in an SD memory card.
Store the file in the standard RAM or standard
ROM.
Store the file in an SD memory card.
• Store the file in the standard RAM.
• If the size of the local device file exceeds
the standard RAM capacity, consider the
use of an extended SRAM cassette.
• Store the file in the standard RAM.
• If the size of the file register file exceeds the
standard RAM capacity, consider the use of
an extended SRAM cassette.
Use the initial device value file in an SD
memory card or the FREAD/FWRITE
instructions.
• Store the file in the standard RAM.
• If the size of the sampling trace file exceeds
the standard RAM capacity, consider the
use of an extended SRAM cassette.
Specify an SD memory card as a backup
destination or restoration source.
Reference
Page 102, Section 2.11
---
---
Page 244, Section 3.25
Page 418, Section 6.2
Page 389, Section 4.7.1
Page 244, Section 3.25,
MELSEC-Q/L Programming
Manual (Common Instruction)
Page 182, Section 3.14 (2)
Page 257, Section 3.31