Mitsubishi Electric Q01UCPU User Manual page 156

(d) External input/output forced on/off timing
The following table lists the external input/output forced on/off timing.
Refresh area
Input and output of modules
mounted on the base unit
Input and output of the CPU
module to be refreshed from
LX/LY of a CC-Link IE
Controller Network module
or MELSECNET/H module
Input and output of the CPU
module to be refreshed from
RX/RY of a CC-Link IE Field
Network master/local
module or CC-Link module
Input and output of the CPU
module to be refreshed from
RX/RY of CC-Link IE Field
Network Basic
154
Input
• During END processing (input refresh)
• At execution of the COM instruction (input refresh)
• At execution of an instruction using direct access
input (DX) (LD, LDI, AND, ANI, OR, ORI, LDP, LDF,
ANDP, ANDF, ORP, ORF)
• At execution of the RFS or MTR instruction
• At execution of an instruction used for a system
interrupt (UDCNT1, UDCNT2, SPD)
• During END processing (refresh via CC-Link IE Controller Network or MELSECNET/H)
• At execution of the COM instruction
• At execution of the ZCOM instruction
• During END processing (auto refresh)
• At execution of the COM instruction (auto refresh)
• At execution of the ZCOM instruction (auto refresh)
• During END processing (auto refresh)
• At execution of the COM instruction (auto refresh)
Output
• During END processing (output refresh)
• At execution of the COM instruction (output
refresh)
• At execution of an instruction using direct access
input (DX) (OUT, SET, DELTA, RST, PLS, PLF,
FF, MC, SFT)
• At execution of the RFS or MTR instruction
• At execution of an instruction used for a system
interrupt (PLSY, PWM)