Mitsubishi Electric Q01UCPU User Manual page 47

(2) File size
The size of a file used in the CPU module depends on the file type. When a file is written to the memory area, the
unit of the stored file size depends on the CPU module and memory area to be written.
( Page 48, Section 2.1.3 (4)) Calculate the rough size of each file with reference to the following table.
File type
Drive heading
*1
Default
With boot setting
With CC-Link IE
Controller Network
setting
With CC-Link IE Field
Network setting
Parameter
With MELSECNET/H
setting
With Ethernet setting
With CC-Link setting
With remote
password setting
Sequence program
Device comment
72
• CPU modules other than the High-speed Universal model QCPU: 464
• High-speed Universal model QCPU: 740
*2
84 + (18 × (number of files))
72 + (total parameter sizes of each module) + (size of the routing setting) + (size of the data link
transfer setting)
Parameter size of each module
Size of the routing setting
Size of the data link transfer setting
72 + (total parameter sizes of each module) + (size of the routing setting) + (size of the data link
transfer setting)
Parameter size of each module
Size of the routing setting
Size of the data link transfer setting
Increase up to 6180/module
Increase up to 922/module
Increase up to the values in the following table (The values indicate an increase per module.)
CC-Link setting
1st module
2nd to 4th modules
5th module
6th to 8th modules
92 + (number of target modules × 10), increase up to 172/module
• CPU modules other than the High-speed Universal model QCPU:
*3
148 + (4 × ((number of steps) + (number of steps of reserved area for online change)))
• High-speed Universal model QCPU:
*3
224 + (4 × ((number of steps) + (number of steps of reserved area for online change)))
• CPU modules other than the High-speed Universal model QCPU:
74 + 8 + (total comment data size of each device)
• High-speed Universal model QCPU:
74 + 72 + 8 + (total comment data size of each device)
Comment data size per device = 10 + 10240 × a + 40 × b
• a: Quotient of ((number of device points)/256)
• b: Remainder of ((number of device points)/256)
CHAPTER 2 APPLICATION OF PROGRAMMING
File size (unit: byte)
Up to 10368 (When only LB/LW(1) is set, 1826 + 16 ×
(number of refresh transfer points).)
6 + 8 × (number of routing settings)
6 + 12 × (number of transfer settings) + 86 × (number of
modules)
Up to 13074
6 + 8 × (number of routing settings)
6 + 16 × (number of RX transfer settings) + 16 × (number
of RWr transfer settings)
Mode setting
Ver.1 mode Ver.2 mode
550 bytes 572 bytes
536 bytes 558 bytes
550 bytes 566 bytes
536 bytes 558 bytes
2
Ver.2 additional mode
624 bytes
610 bytes
618 bytes
610 bytes
45