802.1X Overview; 802.1X Architecture; Controlled/Uncontrolled Port And Port Authorization Status - HP MSR2000 Configuration Manual

802.1X overview

802.1X is available only on the routers with Layer 2 Ethernet switching interface module installed. For
more information about the Layer 2 Ethernet switching interface modules, see HP MSR Router Series
Interface Module Guide.
802.1X is a port-based network access control protocol initially proposed for securing WLANs, and it
has also been widely used on Ethernet networks for access control.
802.1X controls network access by authenticating the devices connected to 802.1X-enabled LAN ports.

802.1X architecture

802.1X operates in the client/server model. It comprises three entities: the client (the supplicant), the
network access device (the authenticator), and the authentication server.
Figure 15 802.1X architecture
Client—A user terminal seeking access to the LAN. It must have 802.1X software to authenticate to
•
the network access device.
• Network access device—Authenticates the client to control access to the LAN. In a typical 802.1X
environment, the network access device uses an authentication server to perform authentication.
Authentication server—Provides authentication services for the network access device. The
•
authentication server authenticates 802.1X clients by using the data sent from the network access
device, and returns the authentication results to the network access device to make access decisions.
The authentication server is typically a RADIUS server. In a small LAN, you can use the network
access device as the authentication server.
Controlled/uncontrolled port and port
authorization status
802.1X defines two logical ports for the network access port: controlled port and uncontrolled port. Any
packet arriving at the network access port is visible to both logical ports.
Controlled port—Allows incoming and outgoing traffic to pass through when it is in the authorized
•
state, and denies incoming and outgoing traffic when it is in the unauthorized state, as shown
in Figure
in the unauthorized state, if the client has failed authentication.
Uncontrolled port—Is always open to receive and transmit authentication packets.
•
16. The controlled port is set in authorized state if the client has passed authentication, and
50