Assembly - Grizzly G0820 Owner's Manual

Assembly

The machine must be fully assembled before it
can be operated. Before beginning the assembly
process, refer to Needed for Setup and gather
all listed items. To ensure the assembly process
goes smoothly, first clean any parts that are cov-
ered or coated in heavy-duty rust preventative (if
applicable).
To assemble sliding table saw:
1. Remove shipping brace shown in Figure 18
from end of sliding table.
Shipping Brace
Figure 18. Shipping brace location.
2.
Attach end cap with (2) pre-installed M4 x 8
tap screws (see Figure 19).
x 2
Figure 19. End cap attached to sliding table.
-24-
3. Pull sliding table forward a few inches and
attach end plate with handle, as shown in
Figure 20, using (2) M6-1 x 20 button head
cap screws, (4) 6mm flat washers, (2) 6mm
lock washers, and (2) M6-1 hex nuts.
End Plate
w/Handle
Figure 20. End plate with handle installed onto
4.
Attach end cover to sliding table with (3) pre-
installed M5-.8 x 10 button head cap screws
(see Figure 21).
5.
Slide M12-1.75 T-nut on push handle assem-
bly into T-slot at front end of sliding table, as
shown in Figure 21, then tighten handle. It
may be necessary to loosen T-nut first.
Note: Make sure pre-installed 12mm flat
washer and 12mm copper washer are posi-
tioned in front of T-slot, as shown in Figure 21.
End Cap
Figure 21. End cover and push handle installed.
sliding table.
T-Slot
Push Handle
Model G0820 (Mfd. Since 12/16)
x 2
End Cover
x 3