Grizzly G0820 Owner's Manual page 50

Aligning Scoring Blade
The goal in this procedure is to adjust the scoring
blade vertical and horizontal positions so that the
scoring kerf is the same width as the main blade
kerf and is aligned with it. This will require placing
the straightedge on both sides of the blades mul-
tiple times as you make adjustments.
Tools Needed
Hex Wrench 8mm .............................................. 1
T-Handle Wrench 8mm ..................................... 1
Straightedge ...................................................... 1
To adjust scoring blade position:
1. DISCONNECT MACHINE FROM POWER!
2. Adjust blade tilt to 0° and raise blade all the
way up.
3. If splitter/riving knife is installed, remove
blade guard.
4. Move sliding table all the way forward to
expose the blade cover, lock it in place, then
open blade cover.
5. Align scoring blade horizontally to main blade
body by:
a. Positioning straightedge against flat of
main blade body (not teeth) and extend-
ing it over scoring blade body.
b. Inserting T-handle wrench into right hole
shown in Figure 90, engaging it with
adjustment bolt under table, then rotating
wrench to align bodies of blades.
Note: Rotating T-handle wrench clock-
wise moves scoring blade left and coun-
terclockwise moves it right.
-48-
Straightedge
Qty
Figure 90. Adjusting horizontal position of
6. Align scoring blade kerf to main blade kerf by:
a. Positioning straightedge on one side of
main blade flat on table and against main
blade teeth and scoring blade teeth.
b. Inserting T-handle wrench into left hole
shown in Figure 91, engaging it with
adjustment bolt under table, then rotating
wrench to position scoring blade, so edge
of scoring blade teeth are aligned with
main blade teeth.
Figure 91. Adjusting vertical height of scoring
7. Repeat Step 6 for other side of blades to
verify kerf thickness matches and scoring
blade is aligned with main blade.
8.
Close blade cover, properly reposition blade
guard, and slide table back to center of
machine.
9.
Perform a test cut and check for chip-out. If
there is chip-out, repeat this procedure until
corrected.
Scoring Blade
scoring blade.
blade.
Model G0820 (Mfd. Since 12/16)