Grizzly G0820 Owner's Manual page 30

Before proceeding with the next steps, wear
gloves to protect your hands when handling
and installing blade.
25. Slide main blade (not included) over arbor
with teeth facing to the right, then install
flange (see Figure 33).
Upper Teeth
Facing Right
Flange
Arbor
Nut
Figure 33. Main blade component assembly.
26. While still holding T-handle wrench, thread
arbor nut on counterclockwise and fully tight-
en it to secure blade (see Figure 34).
Arbor Nut
Figure 34. Main blade installed on arbor.
27. Close blade cover, then move sliding table all
the way back and remove T-handle wrench.
-28-
28. Install riving knife or splitter/riving knife, as
Arbor
29. Adjust riving knife or splitter/riving knife
Main Blade
Flange
Figure 36. Adjusting splitter/riving knife-to-blade
shown in Figure 40, but do not tighten
mounting bolt yet (refer to Riving Knife
Alignment beginning on Page 43 for detailed
information).
Mounting Bolt
Figure 35. Installing splitter/riving knife.
approximately ⁄ " away from main blade,
1
8
using a ⁄ " or 3mm hex wrench as a guide
1
8
(see Figure 36).
spacing.
Model G0820 (Mfd. Since 12/16)
Splitter/Riving
Knife
Hex Wrench