Grizzly G0820 Owner's Manual page 28

14. Fully tighten cap screws from Step 11.
15. Attach rip fence scale flush along top edge of
cast-iron table and large extension table (see
Figure 25) with (3) M6-1 x 12 button head
cap screws, (4) 6mm flat washers, and (1)
M6-1 hex nut.
x 2
Large
Extension
Table
Cast-
Iron
Table
Scale
Figure 25. Mounting rip fence scale.
16. The rip fence rail is pre-assembled with
four rail studs and accompanying hardware.
Remove (1) hex nut, (1) lock washer, and (1)
flat washer from end of each stud, as shown
in Figure 26.
Rail Studs
Figure 26. Removing rip fence rail hardware to
prepare for installation.
-26-
x 1
6mm
Flat Washer
M6-1
Hex Nut
6mm
Flat Washer
M6-1 x 12
Button Hd. Cap Screws
17. Insert studs into tables as shown in Figure
27, and attach with hardware removed in
Step 16.
Figure 27. Installing the rip fence rail.
18. Slide rip fence base onto fence rail, as shown
in Figure 28.
19. Thread (2) M10-1.5 x 12 lock handles and
M10-1.5 x 55 lock knob bolt into rip fence
base, as shown in Figure 28.
Fence Base
Knob
Bolt
Figure 28. Rip fence attached with lock handles
and lock knob installed.
Model G0820 (Mfd. Since 12/16)
x 3
Lock
Handles