Grizzly G0820 Owner's Manual page 34

50. On right side of crosscut fence, make sure 0°
stop block is against stop bolt, then secure
fence by threading M8-1.25 x 50 knob bolt
with (1) 8mm flat washer, and (2) M8-1.25
hex nuts into threaded hole on stop block, as
shown in Figure 51.
Stop Block
Figure 51. Knob bolt threaded into 90° stop
block.
51. Attach flip stop (see Figure 52) by threading
knob bolt into T-nut previously installed in top
T-slot of fence.
Knob Bolt
Figure 52. Flip stop installed onto crosscut
fence.
-32-
52. If you installed splitter/riving knife earlier—
Knob Bolt
Flip Stop
Figure 54. Dust hose support attached to rear of
53. Attach dust hose support to large extension
instead of riving knife—raise main blade all
the way up, and attach blade guard with (1)
M10-1.5 x 25 cap screw and (1) M10-1.5 lock
nut, as shown in Figure 53.
Figure 53. Blade guard installed onto splitter.
Dust Hose
Support
large extension table.
table with (1) M10-1.5 x 20 cap screw, (1)
10mm flat washer, and (1) M10-1.5 lock nut
(see Figure 54).
Note: The support can be placed on either
the rear or side of the extension table using
the two available holes.
Model G0820 (Mfd. Since 12/16)