Table of Contents
Advertisement
Lifting & Placing
Straining or crushing injury
may occur from improperly
lifting machine or some of
its parts. To reduce this risk,
get help from other people
and use a forklift (or other
lifting equipment) rated for
weight of this machine.
To lift and place saw:
1.
Position crate as close to installation location
as possible.
2.
Remove top of crate. Position forklift forks as
wide as possible while still fitting under center
opening (see Figure 16).
Figure 16. How to insert forks for lifting table
saw off pallet.
3.
Remove small items packed around saw and
unbolt saw from pallet.
Model G0820 (Mfd. Since 12/16)
HEAVY LIFT!
DO NOT lift saw any higher than necessary
to clear pallet. Serious personal injury and
machine damage may occur if safe moving
methods are not followed.
4.
With an assistant holding each end to help
stabilize load, lift saw with forklift just high
enough to clear pallet, and move it to your
predetermined location.
5.
Lower saw onto ground and back forklift
away.
6.
Place level on cast-iron table.
7.
If not already installed, thread (1) M16-2
hex nut onto each M16-2 x 40 hex bolt,
then thread each bolt into stand corners
(see Figure 17).
Figure 17. Hex bolt (1 of 4) in stand corner for
leveling.
8.
Use hex bolts to level saw table from left-to-
right and from front-to-back. Leveling saw
allows sliding table to move smoothly.
9.
Tighten hex nuts against frame to prevent
hex bolts from moving after leveling.
Harwired machines must be secured to the
floor.
x 4
-23-
Advertisement
Table of Contents
