Grizzly G0820 Owner's Manual page 31

30. Use straightedge to make sure riving knife
or splitter/riving knife and
aligned with main blade, as shown in Figure
37. The alignment should be with blade bod-
ies, not carbide teeth (see inset).
— The riving knife or splitter/riving knife
position can be changed by adjusting set
screws at splitter/riving knife mounting
block. Refer to Riving Knife Mounting
Block on Page 78 for more details.
— The scoring blade alignment can be
changed by adjusting
through table top (see Figure 37). Refer
to Aligning to Scoring Blade on Page 48
for more details.
Scoring Blade Alignment
Scoring Blade Elevation
Figure 37. Access holes for scoring blade
adjustment controls.
31. Close blade cover. Center sliding table over
cabinet body and lock in place with sliding
table lock lever (see Figure 38).
Sliding Table
Lock Lever
Figure 38. Location of sliding table lock lever.
32. Position rip fence
1
Model G0820 (Mfd. Since 12/16)
scoring blade are
bolt accessible
⁄ " away from main blade.
8
33. Slide rip fence stop ring onto left end of rail
and tighten pre-installed set screw to secure
it in place (see Figure 39). When installed
correctly, this ring will prevent rip fence from
contacting blade.
Rip Fence
Stop Ring
Figure 39. Rip fence stop ring attached to rail.
34. Attach rip fence end stop on opposite end of
rip fence rail with (1) M8-1.25 x 15 cap screw
and (1) 8mm lock washer (see Figure 40).
Figure 40. Rip fence end stop attached to rail.
35. Adjust rip fence to main blade and tables,
as instructed in Calibrating Rip Fence on
Page 79.
Rip Fence
End Stop
x 1
-29-