Grizzly G0820 Owner's Manual page 29

20. Slide rip fence onto clamping plate, as shown
in Figure 29, and lock it with slide-lock
handle.
Rip
Fence
Figure 29. Rip fence attached to rip fence base.
21. Move sliding table all the way forward to
expose blade cover. Pull blade cover toward
front of machine to disengage magnetic
catches (see Figure 30).
Figure 30. Location of magnetic catches that
secure blade cover.
The Model G0820 does not ship with a 12"
main blade. Refer to Blade Requirements
and Blade Selection beginning on Page 44
when purchasing the main blade.
Model G0820 (Mfd. Since 12/16)
Slide-Lock
Handle
Clamping
Plate
Magnetic Catch
(1 of 2)
22. Insert T-handle wrench into access hole
shown in Figure 31.
Note: Main blade is shown here only for illus-
trative purposes.
T-Handle
Wrench
Arbor
Nut
Figure 31. Loosening main blade arbor bolt.
23. Push down on T-handle wrench with one
hand as you rotate arbor nut clockwise (it
has left-hand threads). This will force end of
T-handle wrench into arbor indent and pre-
vent arbor from rotating in next steps.
24. Continue unthreading arbor nut clock-
wise until you can remove blade flange
(see Figure 32).
Flange
Figure 32. Flange and arbor nut removed from
arbor.
Access Hole
Arbor Nut
-27-