Grizzly G0820 Owner's Manual page 32

36. Thread M12-1.75 x 55 adjustable lock handle
with a 12mm flat washer through hole in short
side of crosscut table and into a M12-1.75
T-nut plate, as shown in Figure 41.
x 1
T-Nut
Plate
Figure 41. Crosscut lock handle installed on
crosscut table.
37. With assistance from other people, place
crosscut table on swing arm pivot pin and slide
T-slot alignment plates and T-nut plate into
sliding table T-slot, as shown in Figure 42.
Crosscut Table
T-Slot
T-Slot
Alignment
Plates
Figure 42. Attaching crosscut table to machine
frame.
-30-
Lock
Handle
Swing Arm
Pivot Pin
T-Nut Plate
38. Remove tap screws and end cap from cross-
cut fence (see Figure 43).
End Cap
x 2
Figure 43. End cap removed from crosscut
fence.
39. Slide M8-1.25 T-nut into T-slot in bottom of
crosscut fence (see Figure 44) and position
in front of stop bolt.
T-Nut
Stop Bolt
Figure 44. T-nut installed in bottom T-slot of
crosscut fence for stop block.
40. Attach 0° stop block to T-nut with (1) M8-1.25
x 35 cap screw and (1) 8mm lock washer
(see Figure 45).
Note: Make sure threaded hole in stop block
is positioned right of cap screw and aligned
with hole to right of stop bolt.
Threaded Hole
Figure 45. 90° stop block installed.
Model G0820 (Mfd. Since 12/16)
T-Slot
0° Stop Block
Stop
Bolt
Hole