Grizzly G0820 Owner's Manual page 62

Resawing Operations
The table saw motor is pushed to its limits when
resawing. If the motor starts to bog down, slow
down your feed rate. Motor overloading and blade
wear can be reduced by using a ripping blade.
Ripping blades are designed to clear the sawdust
quickly.
Components Needed for Resawing:
Ripping Blade 12" ...............................................1
Clamps ...............................................................2
Shop-Made Resaw Barrier .................................1
You may experience kickback during this
procedure. Stand to the side of the blade
path and wear safety glasses and a full face
shield to reduce risk of injury.
To perform resawing operations:
1.
DISCONNECT MACHINE FROM POWER!
2.
Raise blade guard up and out of the way.
3.
Install rip fence in vertical position.
4.
Place workpiece against rip fence and
slide resaw barrier against workpiece (see
Figure 124).
Workpiece
Resaw
Barrier
/ " Connection
1
8
Figure 124. Ideal completed resaw cut.
-60-
5.
6.
7.
8.
9.
10. Repeat Steps 7–9 until blade is close to half
11. Turn saw OFF, then separate parts of
12. When finished resawing, remove resaw bar-
Rip
Fence
Clamp resaw barrier to table top.
Connect saw to power, lower blade com-
pletely below table, and slide workpiece over
blade to make sure it moves smoothly and fits
between resaw barrier and rip fence.
Raise blade approximately 1", or close to
half the height of the workpiece, whichever is
less.
Turn machine ON, and use push stick to feed
workpiece through blade using a slow, steady
feed rate.
Flip workpiece end for end, keeping same
side against rip fence, and run workpiece
through blade.
the height of workpiece to be resawn.
IMPORTANT: The ideal completed resaw cut
will leave approximately
the resawing is complete, as shown in Figure
124. Leaving a
⁄ " connection will reduce risk
1
8
of kickback.
workpiece and hand plane remaining ridge.
rier and reposition blade guard over blade.
Model G0820 (Mfd. Since 12/16)
⁄ " connection when
1
8