Table of Contents
Advertisement
Calibrating Crosscut Fence
To accurately use the crosscut fence scale and
ensure the end cap does not contact the blade,
the distance between the crosscut fence and the
blade must be properly adjusted.
Tool Needed
Precision Ruler .................................................. 1
To adjust distance between crosscut fence
and blade:
1.
DISCONNECT MACHINE FROM POWER!
2.
Perform "To Position Crosscut Fence" proce-
dure starting on Page 49.
3.
Move crosscut table (refer to Positioning
Crosscut Table Along Sliding Table for
instructions) so fence end cap is aligned with
center of blade body (see Figure 96).
3" Mark
Figure 96. End cap aligned with blade.
4.
Place precision ruler against a blade tooth,
as shown in Figure 96, then adjust fence so
that 3" mark on fence scale is exactly 3" from
blade tooth.
5.
Without disturbing pivot bolt position, lift
fence up (see Figure 94), tighten pivot bolt,
then re-insert pivot bolt into hole.
6.
Repeat measurement in Step 3.
— If measurement is not exactly 3", repeat
Step 4 until it is.
7.
Re-install knob bolts removed earlier to
secure setting.
-50-
Positioning Crosscut Table Along
Sliding Table
The crosscut table can be positioned as neces-
sary along the sliding table (see Figure 97).
Qty
Figure 97. Crosscut table positions along sliding
To position crosscut table along sliding table:
1.
DISCONNECT MACHINE FROM POWER!
2.
Use sliding table lock lever (see Figure 98) to
End Cap
secure table in position.
Figure 98. Location of sliding table lock lever.
table.
Sliding Table
Lock Lever
Model G0820 (Mfd. Since 12/16)
Advertisement
Table of Contents
