Network Time Protocol - Symmetricom TimeCreator 1000 User Manual

Enter MD5 at the authentication protocol prompt.
Enter 123456789ABCDEFGHIJK at the authentication key prompt
Enter DES at the privacy protocol prompt
Enter 123456789ABCDEFG at the privacy key prompt
Displaying Trap Destinations, SNMPv2 Communities, and SNMPv3 Users
The "show snmp" command allow you to display the SNMP configuration. This
includes the SNMPv3 users, SNMPv2 communities, trap version, trap user, and
whether SNMPv2 is enabled (see
Example 1
Use the following command to display the list of SNMPv3 users (admin user level 3
required).
Type
show snmp accessv3
Example 2
Use the following command to display the list of SNMP trap destinations and trap
users (admin user level 3 required).
Type
show snmp trap
Example 1
Use the following command to display the list of SNMPv2 communities (admin user
level 3 required).
Type
show snmp accessv2
Note: Valid authentication key and privacy key characters include
numbers, upper and lowercase letters, and the character set :=?@_.
Do not use spaces in user names.

Network Time Protocol

Network Time Protocol (NTP) is used to synchronize system clocks to a common
time source by transmitting and receiving time of day over a TCP/IP network.
097-93100-01 Revision C – February, 2010
Appendix B Command Descriptions and Communications Interface
Show SNMP, on page 252).
and press Enter.
and press Enter.
and press Enter.
Network Time Protocol
TimeCreator 1000 User's Guide 271