Set IP State
Use this command to enable or disable the specified Ethernet interface. You must
restart the interface after you configure it.
Command Syntax:
set ip-state {eth0|eth1} {enable|disable|restart}
Example 1:
To enable the ETH1 inteface -
tc1000>set ip-state eth1 enable
Example 2:
To restart the ETH1 inteface -
tc1000>set ip-state eth1 restart
Remarks: Restart disables the interface and then enables it.
Related:
show ip
Level :
Power-User and Admin only
097-93100-01 Revision C – February, 2010
Appendix B Command Descriptions and Communications Interface
CLI Commands
TimeCreator 1000 User's Guide 225