Snmp Traps; Mib Var Bindings For Symmetricom- Specific Traps - Symmetricom TimeCreator 1000 User Manual

Appendix A Alarms, Events and SNMP Traps

SNMP Traps

SNMP Traps
The MIB for TimeCreator 1000 v1.2 has MIB var bindings for all Symmetricom
specific SNMP traps, as shown in
Table A-4. MIB Var Bindings for Symmetricom- specific Traps
trapID
trapAID1
trapAID2
trapState
trapSeverity
trapTimestamp
trapDescription
trapValue
See Figure A-1,
table entries.
Note: Users need to load 2 mib files into their MIB browser:
The symm-smi.mib file must be loaded first before TC1000.my file.
(The "TC1000.my" file was originally named
and v1.0 of TimeCreator 1000.)
148 TimeCreator 1000 User's Guide
Table A-4
A unique string assigned to each trap
integer, trap AIDs
integer, trap AIDs
The TimeCreator 1000 provides set and clear trap messages to
notify you when certain conditions are exceeding the
user-specified levels (when traps are set) and when certain
conditions return to within the user-specified levels (when traps
are cleared). Traps also indicate hardware and signal status.
These are integer values, where:
clear (1) - the condition for this trap has been cleared,
set (2) - the trap condition has been raised
A 32 bit-wise value:
minor (1), major (2), critical (3), clear (4), nonalarm (5)
The time when the trap was generated
A string description for the trap
String, trap value
Figure A-2, and Figure A-3
symm-smi.mib

TC1000.my

below:
for details about other relevant MIB
"TC1000.mib" in v1.1
097-93100-01 Revision C – February, 2010