Show status (general status of unit)
Show gps (GPS information)
Show inventory
See
Backing up Provisioning
Enabling Outputs
Enter the following command to set the interface state.
Example for port 5:
Set interface state port 5 enable
Setting The Output To Test Mode
Enter the following command to set the interface test mode.
Example for port 9:
Set interface test-mode port 9 enable
Configuring For Default Mode (Real Time Clock)
Enter the following commands to set the TOD source to RTC"
Set tod-source rtc
Sync tod-source now
Configuring For User Mode
Enter the following command to set the clock in user mode:
Set tod-source user
Example to set the clock in user mode:
Set clock date 2006-05-20 time 10:23:00
Sync tod-source now
Configuring For GPS Mode
Enter the following commands to the TOD source to GPS:
097-93100-01 Revision C – February, 2010
Chapter 4 General Guidelines for using the Symmetricom TimeCreator 1000
Data, on page 110 for additional details.
CLI commands
TimeCreator 1000 User's Guide
67