Adding A User - Symmetricom TimeCreator 1000 User Manual

If the TimeCreator 1000 is connected to a PC directly through the serial port, start
a session and press Enter.
3. Type your user name and press Enter. The system prompts for a password.
4. Type your password and press Enter. The system prompt appears.
Note: The unit's default user name is admin and the default password
is SymmTC1000. To avoid unauthorized access, you should change
the default user name and password.

Adding a User

Use the following procedure to add a user to the system access list.
Note:
User passwords can consist of alphanumeric characters, "~", "*",
"(",")", "!", "?", "-", "_", and "." with a minimum of 8 characters and a
maximum of 32 characters.
Usernames can consist of numbers, upper and lower case letters,
dash "-", and underscore "_", with a maximum of 20 characters.
Usernames cannot use a leading dash "-" or underscore "_" as the
first character. Usernames cannot use any of the following
characters:
/ ( ) | \ ; : " ' , < >
Passwords must contain at least one number or special character.
For a description of user access levels, see
Access
1. Login at the Admin level (see Login, on page 74).
2. Type
show user
3. Type
set user add
4. Type a user name and press Enter. The name you enter will be the log-in name
for the user. The system prompts you for the user access level.
5. Type the user access level and press Enter. The system prompts you for a
password.
6. Type a password and press Enter. The password you enter will be the log-in
password for the user. The system responds with the confirm password prompt.
097-93100-01 Revision C – February, 2010
List, on page 74.
and press Enter to view the current list of users.
and press Enter. The system prompts you for a user name.
Chapter 5 Provisioning
Managing the User Access List
Managing the User
TimeCreator 1000 User's Guide 75