Symmetricom TimeCreator 1000 User Manual page 222

Appendix B Command Descriptions and Communications Interface
CLI Commands
eth1
lo
Remarks: Use
settings. Use
status version of the command gives the Ethernet link status and the IP interface
status.
Related:
set ip
Level : User, Power-User and Admin
Set IP
Use this command to provision the Host address, Mask, Gateway, and Broadcast IP
settings for both Ethernet interfaces.
Command Syntax:
set ip {eth0|eth1} {addr|mask|gateway|broadcast} <address>
Example:
To set the IP address for ETH1 to 192.168.7.44 -
tc1000>set ip eth1 addr 192.168.7.44
Remarks: The address format allows IPv4 and IPv6 multiple octet formats. Use
IP-State to disable the interface while configuring the system. The mask is defined
as an integer defining the number of 1-bits from the MSB. The rest of the bits are 0.
For example a value of 24 corresponds to 255.255.255.0
222 TimeCreator 1000 User's Guide
Link encap:Ethernet
inet addr:10.0.0.101
UP BROADCAST RUNNING MULTICAST
RX packets:2233926 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:139026829 (132.5 Mb)
Interrupt:9 Base address:0xf000 Memory:fbfaf000-fbfb0000
Link encap:Local Loopback
inet addr:127.0.0.1
UP LOOPBACK RUNNING
RX packets:665 errors:0 dropped:0 overruns:0 frame:0
TX packets:665 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:101158 (98.7 Kb)
to display the current user-selected configuration
show ip config
to display the current interface configuration. The
show ip status
HWaddr 00:B0:AE:01:25:86
Bcast:10.0.0.255 Mask:255.255.255.0
MTU:1500
TX bytes:0 (0.0 b)
Mask:255.0.0.0
MTU:16436 Metric:1
TX bytes:101158 (98.7 Kb)
097-93100-01 Revision C – February, 2010
Metric:1