Provisioning Snmp - Symmetricom TimeCreator 1000 User Manual

Example:
To abort the root server recovery process under way, enter the following command:
1. Login at the Admin or Power-User level (see Login, on page 74).
2. Type
show root-recovery status
root server recovery process and expected time for re-alignment.
3. Type
set root-recovery autorecoverymode abort

Provisioning SNMP

Enabling SNMP allows you to use an SNMP interface to remotely manage the
TimeCreator 1000 over an Ethernet connection. This also allows the user to:
provision SNMPv2 to be enabled or disabled on the specified Ethernet port

provision the SNMP trap destination to the specified IP address and SNMPv3

user or SNMPv2 community, or to the default settings
add/delete/modify SNMPv3 users

add/delete/modify SNMPv2 communities

Example 1:
To enable SNMP on the MGMT port, add an SNMPv3 user ABC, with no
authorization or privacy, and to set the trap destination IP address to
192.168.100.100, port 1098, for user ABC with a security level of "noauth" and an
access level of "ro", perform the following steps:
1. Login at the Admin or Power-User level (see Login, on page 74).
2. Type
set service snmp enable
3. Type
set snmp accessv3 add ABC securLvl noauth accessLvL ro
press Enter.
4. Type
set firewall snmp enable
097-93100-01 Revision C – February, 2010
and press Enter to verify the status of the
and press Enter.
and press Enter.
and press Enter.
TimeCreator 1000 User's Guide 103
Chapter 5 Provisioning
Provisioning SNMP
and