Symmetricom TimeCreator 1000 User Manual page 262

Appendix B Command Descriptions and Communications Interface
CLI Commands
Sync TOD-Source
Use this command to change the time and phase of the DTI outputs by
synchronizing with the TOD source. Use this command to provision the
TOD-Source to "jam sync" when the command is issued or at the specified
date/time.
Command Syntax:
sync tod-source {now | yyyy-mm-dd hh:mm:ss}
Example 1:
To jam sync immediately:
tc1000>sync tod-source now
Example 2:
To jam sync on March 23, 2011 at exactly 12:30 pm:
tc1000>sync tod-source 2011-03-23 12:30:00
Related:
set tod-source, show tod-source
Level : Power-User and Admin only
262 TimeCreator 1000 User's Guide 097-93100-01 Revision C – February, 2010