Table of Contents
Advertisement
Chapter5 Troubleshooting
Warning / Error Messages
If some trouble occurs, the buzzer sounds and the display shows a corresponding error message.
Take an appropriate remedy for the displayed error.
Warning messages
Errors when performing operations
Message
INVAILD OPERATION
:MEDIA UNDETECT
INVAILD OPERATION
:MOTOR POWER OFF
INVAILD OPERATION
INK ERROR
INVAILD OPERATION
COVER OPEN
INVAILD OPERATION
DATA REMAIN
INVAILD OPERATION
EMERGENCY SWITCH
INVAILD OPERATION
WASH UNIT ORG.
Message displayed in LOCAL
Message
Can't print/cartridge
Check waste ink
Replace WIPER
DATA REMAIN
MACHINE TEMP./H **°C
MACHINE TEMP./L **°C
5-4
Cause
Operation cannot be performed because
no media is detected.
The motor is OFF after the cover was
opened etc.
An ink error occurred.
The front cover or the maintenance
cover is opened.
Data was received.
The emergency stop switch was
pressed.
The origin of the belt wash unit cannot
be detected.
Cause
Multiple ink errors (unusable ink) have
occurred, making it impossible to feed
ink (printing and cleaning, etc.).
The waste ink tank count has exceeded
the prescribed amount.
The used count of wiper has exceeded
the prescribed number.
Print data is received in LOCAL.
Stable printing cannot be done because
temperature in the installed environment
(printer) is too high.
Stable printing cannot be done because
temperature in the installed environment
(printer) is too low.
Solution
• Execute after media is detected.
• Return to LOCAL and execute the operation
after completion of initialization.
• Execute the operation after replacing with a
new ink pack.
• Execute the operation after closing the
cover.
• Execute the operation after executing data
clear. (
P.2-29)
• Release the emergency stop switch to return
to normal function.
• Turn off the main power to the machine and
turn it on after a while.
If the same error message appears again,
contact your local distributor to call for ser-
vice.
Solution
Replace with a new ink pack.
Check the amount of waste ink in the waste
ink tank.
Conduct maintenance and waste ink tank
replacement, and reset the amount of waste
ink.
Execute maintenance, station maintenance
and wiper exchange and replace the wiper.
Shift to REMOTE and execute printing.
Or, execute data clear and cancel printing.
Adjust the ambient temperature to within the
specified scope (20°C to 35°C).
Advertisement
Table of Contents
Troubleshooting
