Ethernet Port Test
To Activate Input Change Display Tests
Set the SW3 rotary switch to the positions shown in
Switch Position
SW3 set to 3
SW3 set to 4
The onboard Ethernet tests display diagnostic information about Ethernet connections.
To Test the Ethernet Port
1. Set switch SW3 to the position shown in
Table 10-7: Ethernet Test Switch Settings
Switch Position
SW3 set to 8
2. Observe the LCD display for test results.
Table 10-6: Input Test Switch Settings
Function
Two-second LED input change display is on (slow mode)
One-second LED input change display is on (fast mode)
Table 10-7 on
Function
Tests the Ethernet Port
iSTAR Ultra Installation and Configuration Guide
Diagnostic Tests
Table
10-6.
page 10-7.
10–7